Knowledgebase
Centralite.com | All together now > CentraLite Help Desk > Knowledgebase

Search help:


StarLite diagram for Honeywell keyfob

Solution Need contact diagram for StarLite MCS and Honeywell code encryptor.

1.   Locate the "INPUT" connector on the rear of the StarLite Master Control Station.  It is located on the right side of the rear panel when looking at it from the rear.

2.   The connector is supplied with a match connector, and you will connect the following wires from the KeyFob Receiver to the following pins.  (Pins are 1 - 5, Left to right.)

      a.   Solid White and Solid Brown are connected to Pin 5.  This is the last pin on the right side of the connector.  (Common Input.)

      b.   Brown/White is connected to Pin 1 of the input connector, and it is the first pin on the left of the connector.  (Input #1.)

      c.   Red/White is connected to Pin 2 of the input connector, and it is the second pin from the left of the connector.  (Input #2.)

3.   Connect the transformer to the receiver as follows:

      a.   Connect the black wire from the receiver to the black w/ white stripe of the transformer

      b.   Connect the Red wire from the receiver to the black wire of the transformer.

4.   Assign the inputs in the software to make them operational.

"""

 
Was this article helpful? yes / no
Article details
Article ID: 175
Category: StarLite Troubleshooting
Date added: 2006-10-04 20:15:51
Views: 1685
Rating (Votes): Article rated 3.4/5.0 (53)

 
« Go back

 
Powered by Help Desk Software HESK - brought to you by Help Desk Software SysAid