Knowledgebase
Centralite.com | All together now > CentraLite Help Desk > Knowledgebase

Search help:


How to set a Dimmer or a Keypad to factory default?

Solution How do I set a Dimmer or a Keypad back to the factory default setting?


Pull out the air gap switch.
Press and hold the top button on a three-button device or the single button of a one-button device.
Restore power to the device by pressing in the air gap switch while still holding the button.
When the power is restored, the top indicator light will begin to flash; keep the button pressed until the indicator light turns off.
This usually takes around four seconds.

The device is now restored to factory settings and is now available to join a JetStream Network.

"""
 
Was this article helpful? yes / no
Article details
Article ID: 365
Category: JetStream Programming
Date added: 2008-02-25 21:08:43
Views: 3050
Rating (Votes): Article rated 3.1/5.0 (70)

 
« Go back

 
Powered by Help Desk Software HESK - brought to you by Help Desk Software SysAid