Knowledgebase
Centralite.com | All together now > CentraLite Help Desk > Knowledgebase

Search help:


How do I reset the RS-232 Bridge to factory default?

Solution How do I reset the RS-232 Bridge back to the factory default setting?

       Unplug the power supply of the device.
       Press and hold the button on the front right.
       While holding down the button, plug the power supply back in.
       Continue holding down the button until you see the left LED flashing rapidly.
       Release the button when the LED stops flashing.
       The right LED will turn on for about 5 seconds (DO NOT PULL POWER UNTIL LED STARTS SLOW BLINKING!!!).

When the Right LED starts blinking slowly, the RS-232 Bridge is back to factory default settings.

"""
 
Was this article helpful? yes / no
Article details
Article ID: 366
Category: JetStream Programming
Date added: 2008-02-25 21:10:58
Views: 1543
Rating (Votes): Article rated 3.3/5.0 (60)

 
« Go back

 
Powered by Help Desk Software HESK - brought to you by Help Desk Software SysAid